Configuration - Daikin VAM150FC Installation Manual

Power cord connection, control wire terminals and switches
on the electronic control unit (printed circuit board)
I
Connect the power cord to the L and N terminals.
I
Secure the power cord with the power cord clamp, as shown in
"Opening the switch box" on page
I
Be sure to connect the electric grounding (earth).
2
L N
3
1
X27A
X1A
16
SS1
15
14
13
12
1 Power supply
2 Terminals
3 Supply air fan
4 Exhaust air fan
5 Damper
6 Primary
7 Power supply PCB
8 Secondary
9 No voltage external input
VAM150+250FC
Total Heat Exchanger
HRV (Heat Reclaim Ventilation)
4P586307-1 – 2019.06
8.
4 5
X3A
X2A
NOR
H
M
P2 P1 F1 F2 J1 J2 J3 JC
11 10 9
10 Centralized control
11 Remote controller
12 Factory setting (no operation
if remote controller is
attached)
13 BRP4A50A (optional
accessory)
14 Damper
15 Indoor air thermistor
16 Outdoor air thermistor
C
ONFIGURATION
Using the remote controller of the VRV-system air conditioner to
make HRV unit settings
The settings (format: XX(XX)-X-XX), for example 19(29)-1-02, that
are uned in this chapter are composed of 3 parts, divided by "-":
I
Mode number: for example 19(29), where 19 is the mode
number for group settings and 29 is the mode number for
individual settings.
I
Switch number: for example, 1
I
Position number: for example, 02.
Operating procedure
You can use either the user interface of the heat reclaim ventilation
units or of the air conditioner to adjust the heat reclaim ventilation unit
settings.
6
Initial setting
7
8
1 Mode nos. 17, 18 and 19: Group control of HRV units.
2 Mode nos. 27, 28 and 29: Individual control
To change the settings with BRC1E53
Make sure that the switch box lids on the heat reclaim ventilation unit
are closed.
1 Shortly press a button to turn on the screen light.
2 Press and hold the Cancel button (1) for at least 4 seconds to
enter the Service Settings menu.
3 Go to Field Settings with the Up/Down buttons and press the
Menu/Enter button (2).
4 Press the Left/Right buttons to highlight the number under
Mode.
5 Press the Up/Down buttons to select the required mode number.
Result: Depending on the mode number that you select,
starting at 20, you will also have to select a unit number, for the
individual control.
6 Use the Left/Right buttons to highlight the number under Unit
No.
7 Use the Up/Down buttons to select an indoor unit number.
Selecting a unit number is NOT necessary when you are
configuring the entire group.
8 Use the Left/Right buttons to select a position number (0 to 15)
for the switch number that you want to change.
In case of individual settings:
Field Settings
Unit No. Mode
0 20
Return Setting
In case of group settings:
Field Settings
Mode
10
Return Setting
9 Use the Up/Down buttons to select the required position
number.
Installation manual
10