Table of Contents
Advertisement
6.
Press the wireless mode
button
on the pump.
red.
7.
On the remote, turn the
wireless power switch
on
.
The bluetooth light will
flash blue, then turn
solid when connected.
Once connected, light 1
8.
Press and hold the ad-
vance button
for ap-
proximately three sec-
onds.
Light 1 will turn steady
red.
Release the advance
button
.
NOTE:
of activating wireless mode.
9. Press and hold the re-
tract button
for ap-
proximately three sec-
onds.
Light 2 will turn steady
red.
Release the retract but-
ton
. Initiation will be-
gin.
NOTE: This step must be done within twenty seconds
of the advance button
10. When the cycle is com-
plete, the cut indicator
will light:
Green (right) =
Full pressure
reached
Red (left) =
Full pressure NOT
reached
3
sec
3
sec
being pressed.
Light
Indicator
Solid Green Tool reached full pressure.
Solid Red
Tool did not reach full pressure.
NOTE: If the indicator shows red, check the oil
levels and ensure that no leaks are happening in
the at-tachments. Confirm that all connections are
secure and the attachments are proper for the job.
Repeat the steps under "Operation". If the problem
persists, return the tool to a MILWAUKEE
facility.
MAINTENANCE
To reduce the risk of injury,
WARNING
always unplug the charger and
remove the battery pack from the charger or tool
before performing any maintenance. Never
disassemblethe tool, batterypack or charger.
Contact a MILWAUKEE
repairs.
Maintaining Tool
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
Inspect your tool for issues such as undue noise,
misalignment or binding of moving parts, breakage
of parts, or any other condition that may affect the
tool operation. Return the tool, battery pack, and
charger to a MILWAUKEE
repair. After six months to one year, depending on
use, return the tool, battery pack and charger to a
MILWAUKEE
service facility for inspection.
®
If the tool does not start or operate at full power with
a fully charged battery pack, clean the contacts on
the battery pack. If the tool still does not work
properly, return the tool, charger and battery pack,
to a MILWAUKEE
®
Service Interval
Refer to the ONE-KEY App for information
regarding necessary servicing, such as fluid
replacement. Return the tool to a MILWAUKEE
service facility for all repairs and maintenance.
NOTE: The week and year of tool manufacture may
be needed. This information can be found on the
serial number located on the tool nameplate.
CODE: K15AD XXXXXXXXX
Before transporting:
• Depressurize the tool by holding down the manual
• Drain the tool of oil and dispose of oil in accordance
to local law and regulations.
• Plug the vent.
• Wrap the tool in plastic to prevent any remaining oil
spillage.
7
service facility for ALL
®
service facility for
®
service facility for repairs.
YEAR WEEK
Transport
®
service
®
Advertisement
Table of Contents
