Split system (Single phase and 3-phase type)
6.2.6 FAN MOTOR removal
Remove the 4 mounting screws.
Cut the binder.(2 places)
6.2.7 TOP PANEL removal
Screw
(with washer)
Remove the mounting screws.
6.2.8 PIPE COVER FRONT removal
Screw
Screw
(serrated)
(with washer)
Remove the mounting screws.
106
Remove the FAN GUARD
by sliding upward.
Loose the clamp, and
remove the lead wires
Screw
Screw
(with washer)
(serrated)
Hook
Remove the PIPE COVER FRONT.
Remove the Hex Socket Screw and
remove the PROPELLER FAN.
Note at the installation.
Insert propeller Fan and Moter shaft reference D
cutting position.
And the tightening torque at the installation.
Tightening torque is from 10 to 15Nm.
Remove the 4 mounting screws.
Remove the FAN MOTOR.
Remove the TOP PANEL.
Maintenance Document 1544-1