Fireplace Specifications; Installing The Chimney System - Superior ST-1 Series Installation Instructions Manual

Note: If the fireplace
$
instailed againsr an inside
I-.
wall, the Class I duct may be extended into
a
,entilatedatf~ space at least
1B'
(457mm) above
fhe anic floor. Secure the duct h o d to a vertical
post with the inlet positioned downward. Ensure
nothing blocks the hood opening. lhe dud must
never terminate higher than the chimney.
I
Two(2) screws. Insert hood intoopening. securein
'
placewithnailsdf~enthrough holesinhaodllange.
Seal with non-combustible watemroof silicon t w
Step 9. Cut or kame hole through !he outside wall
lor the installatun of the dud inlel hood. A 4 112'
(1 14mm) diameter hole issuflident. Feed iheloose
end aflhe flexible duct through the hole cul lor the
Inlet Hcod and attach lo mllar on lnlet Hood using
.
,
cauking. It additional duct is needed, use Class 1
metdlic dud.
1
INSTALLING THE CHIMNEY SYSTEM
Step 1.Chedclluedamperforproperqeration. To
open, slide handle to lhe let and release. Damper
will open automatically. To dose, pull handle down
slide right. Damper will be lxked in the closed
position.
Step 2. Using standard mnslnrdian framing tech-
niques, mnslmct qening lor chimney route up
-
lhroughtheceiling(s)and roolorthrough anoutside
: m e .
Framing musmaintainadequateminimumairspace
dearance at all times.
CALITON: ALLOW MINIMUM
1"
(25MM) (SEE
"NOTEJ CHIMNEY AIR SPACE TO COMBUS-
TIBLE FRAMING MEMFERS THROUGHOUT
VERTICAL CR OFFSET ClllMNEY INSTALLA.
-
~
TION. ALSO MAINTAIN AIR SPACE ONTOP OF
THE FIREPLACE AS DEFINED BY THE SPAC.
ERS AND STANDOFFS (FIGURE 11
1.
1"
A!rSpco
(Tan Canada)* ln Canada)
lT
Air Spaca
Figom 11
"Note:2"(51mmJ alrspace to combustibles
requlred when Installing Model
ST-3840-1 in
6
Canada.
FIREPLACE SPECIFICATIONS
pJ.
(546mm)
-
TCQ
Vl e w
Figure 1 2
Accessary Access
End
Vl e w
Opposing
End
View
Figure 13 Figure
14
Fmnt
Vi e w
Figure
15