Specifications - Stihl MS 200 T Instruction Manual

Specifications

EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Engine
STIHL single cylinder two-stroke engine
MS 200 T
Displacement: 2.15 cu. in.
(35.2 cm
Bore: 1.60 in (40 mm)
Stroke: 1.10 in (28 mm)
Engine power to 2.1 hp (1.6 kW)
ISO 7293: at 10,000 rpm
Idle speed: 2,800 rpm
High speed setting
when performing
repairs (with bar and
chain): 14,000 rpm
Ignition System
Electronic magneto ignition
Spark plug (resistor Bosch WSR 6 F,
type): NGK BPMR 7 A
Electrode gap: 0.02 in (0.5 mm)
Fuel System
Fuel tank capacity: 12.5 fl.oz (0.37 L)
Chain Lubrication
Fully automatic, speed-controlled oil
pump. Additional manual oil flow control
Oil tank capacity: 8.1 fl.oz (0.24 L)
Weight
dry, without bar and
chain: 7.9 lbs (3.6 kg)
Cutting Attachment
3
)
Recommended cutting attachments
complying with Section 5.11 of ANSI B
175.1-2000.
Observe notes on ANSI B 175.1-2000
and definition of "low kickback chain" in
chapter on "Safety Precautions and
Working Techniques".
Rollomatic E guide bars
Reduced kickback STIHL guide bar
(with green label)
Cutting
lengths:
Pitch:
Groove width: 0.50 in. (1.3 mm)
Nose sprocket: 9-teeth
3/8" P Chain
Low kickback STIHL saw chain (with
green label)
Picco Micro Comfort 3 (63 PMC3)
Pitch:
Drive link gauge:
Chain sprocket
6-tooth for 3/8" P (spur sprocket)
To ensure compliance with the kickback
properties required in Section 5.11 of
ANSI B 175.1-2000, only use
replacement chains that, when used
with this specific powerhead, comply
with Section 5.11 of the ANSI standard
or are classed as "low kickback" chains
according to ANSI B 175.1-2000.
English
12, 14, 16 in.
(30, 35, 40 cm)
3/8" P (9.32 mm)
3/8" P (9.32 mm)
0.050 in. (1.3 mm)
45