Stihl MS 200 T Instruction Manual page 13

Warning!
Breathing asbestos dust is dangerous
and can cause severe or fatal injury,
respiratory illness or cancer. The use
and disposal of asbestos-containing
products have been strictly regulated by
OSHA and the Environmental Protec-
tion Agency. If you have any reason to
believe that you might be cutting asbes-
tos, immediately contact your employer
or a local OSHA representative.
Warning!
To reduce risk of elec-
trocution, take extra
precautions when cutting
near power lines. Have
the power switched off
before starting cutting
work in the immediate vicinity of power
lines.
Operating Instructions
Warning!
Do not operate your chain saw with the
starting throttle lock engaged. Cutting
with the starting throttle lock engaged
does not permit the operator proper
control of the saw or chain speed. Begin
cutting with the saw at full throttle,
engage the bumper spike firmly in the
wood (if possible) and then continue
cutting. Always work with the bumper
spike so that you have better control of
the saw. If you work without the bumper
spike the saw may pull you forwards
suddenly.
MS 200 T
Warning!
Never touch a chain with your hand or
any part of your body when the engine
is running, even when the chain is not
rotating.
In the event of an emergency, switch off
the engine immediately – move the
master control lever to 0 or STOP.
Warning!
Always stop the engine before putting a
chain saw down.
Warning!
The saw chain continues to move for a
short period after the throttle trigger is
released (flywheel effect).
Accelerating the engine while the saw
chain is blocked increases the load and
will cause the clutch to slip continuously.
This may occur if the throttle is
depressed for more than a few seconds
when the chain is pinched in the cut or
the chain brake is engaged. It can result
in overheating and damage to important
components (e. g. clutch, polymer
housing components) – which can then
increase the risk of injury, e. g., from the
saw chain moving while the engine is
idling.
Warning!
Your chain saw is equipped with a chain
catcher. It is designed to reduce the risk
of personal injury in the event of a
thrown or broken chain. From time to
time, the catcher may be damaged or
removed. To reduce the risk of personal
injury, do not operate a chain saw with a
damaged or missing chain catcher.
Warning!
Inspect antivibration elements periodi-
cally. Replace damaged, broken or
excessively worn antivibration elements
immediately, since they may result in
loss of control of the saw. A "spongi-
ness" in the feel of the saw, increased
vibration or increased "bottoming" dur-
ing normal operation may indicate
damage, breakage or excessive wear.
Antivibration elements should always
be replaced in sets. If you have any
questions as to whether the antivibra-
tion elements should be replaced,
consult your STIHL servicing dealer.
If this tool is subjected to unusually high
loads for which it was not designed (e. g.
heavy impact or a fall), always check
that it is in good condition before
continuing work. Check in particular that
the fuel system is tight (no leaks) and
that the controls and safety devices are
working properly. Do not continue
operating this machine if it is damaged.
In case of doubt, have it checked by your
STIHL servicing dealer.
Your saw is not designed for prying or
shoveling away limbs, roots or other
objects. Such use could damage the
cutting attachment or AV system.
English
11