Satellite Status Page; Turn Advisory And Arrival Annunciations - Garmin 500W Series Pilot's Manual & Reference

Waypoint already exists — The name you have entered
for a user waypoint already exists in memory.
Waypoint(s) have been replaced — One or more user
waypoints were updated during a unit-to-unit crossfill
operation.
Waypoint memory is full — You have used all 1000 user
waypoint locations in the 500W-series unit memory. Delete
unwanted waypoints to make room for new entries.
190-00357-00_0B 500W Pilot Guide197 197

Turn Advisory and Arrival Annunciations

The following annunciator messages may appear in the
lower right corner of the 500W-series unit display:
Arriving at waypoint — Arriving at the destination
waypoint for the active leg.
Hold direct — "Direct" holding pattern entry.
Hold parallel — "Parallel" holding pattern entry.
Hold teardrop — "Teardrop" holding pattern entry.
Left to xxx° in xx sec — Turn advisory. Turn to the indi-
cated heading by the time shown.
Left to xxx° now — Turn advisory. Turn to the indicated
heading by the time shown.
Next DTK xxx° in xx sec — Waypoint alert. Prepare to
turn to the indicated heading upon waypoint passage.
PTK end in xx sec — Parallel Offset is terminating.
Right to xxx° in xx sec — Turn advisory. Turn to the
indicated heading by the time shown.
Right to xxx° now — Turn advisory. Turn to the indicated
heading by the time shown.
190-00357-00 Rev B
12 - MESSAGES
ABBREVIATIONS &
NAV TERMS
197
9/7/2007 3:11:07 PM