Samsung ML-6060 Technical Instructions page 8

8
Photo 37
Notes
Need trust-worthy, detailed Technical
Instructions for another engine?
Visit: www.futuregraphicsllc.com
E-mail: info@futuregraphicsllc.com
Photo 35
Photo 36
Photo 38
Photo 39
Photo 40
ML-6060/1650 Technical Instructions
Step 33
Place the developer roller drive gear onto
the rollers axle.
(See Photo 35)
Step 34
Apply padding powder to the drum.
Install the drum into the cartridge.
(See Photo 36)
If the drum axle is installed in the drum
slide the axle out from the small gear end
as far as possible. Install the drum axle
into the side of the cartridge.
(See Photo 37)
Carefully lower the drive gear end of the
drum into the cartridge and slide the
drum axle back into the drum.
Step 35
Carefully place the waste hopper into the
cartridge. Install the two screws that hold
the waste hopper in place.
(See Photo 38)
Step 36
If the drum axle is not attached to the
drum, slide the drum axle into the drum
starting on the gear side so the screw
hole in the axle is visible on the gear side.
(See Photo 39)
Step 37
Install the three toner hopper agitator
gears.
(See Photo 40)
Website: www.futuregraphicsllc.com