Jacuzzi LG72000 Installation Manual & Warranty Information page 8

English
Fuzion ® Frame Installation
If you are installing a Fuzion
frame, please refer to the Fuzion
Guide (#GL44000) before proceeding any further.
Complete the installation and assembly steps according
to the Fuzion ® Frame Installation Guide.
Fuzion ® Control Panel Installation
The following cutouts must be clear and free of any dirt
or adhesive:
- Control panel cutout in the assembled wood frame
- Control panel cutout in the assembled counter
- Control panel cutout in the bathtub
1. Insert the wire connector into the back of the control panel
(Figure 5).
2. Sparingly apply adhesive around the base of the control
panel (Figure 6).
3. Thread the wire through the cutout and to the control box.
4. Orient control panel in the following manner: the logo will
be on the right side of the J4 control panel when you are
sitting in the bathtub (the power button will be on the right
side of the J5 LCD control panel).
5. Lower the control panel into the cutout and press firmly to
embed the adhesive (Figure 7).
6. Connect the wire to the control box.
7. Please proceed to Step 3 in the Drop-In Installation
section on page 10.
Page 8
Fuzion Specific Material (Continued)
®
® bathtub with accessory
® Frame Installation
www.jacuzzi.com
Fuzion ® Frame
Installation
Fig. 5
Control Panel
Control Box Wire
(Black Wire)
Control Box Wire
(Adhesive)
Fig. 6
Adhesive Application
Fig. 7
Inside of Bathtub
Control Panel