3Com SUPERSTACK 4226T Getting Started Manual page 37

If there is no response, wait for one minute then re-enter the default IP
address.
3 At the login and password prompts, enter
press Return at the password prompt (default user name and password).
If you have logged on correctly, a set of Getting Started pages are
displayed.
4 The Getting Started pages allow you to enter basic setup information for
the Switch. Select Manual and then enter the IP address, subnet mask,
and default gateway that you want the Switch to use when it is
connected to the network. The final page displays a summary of the
information entered.
The initial set up of your Switch is now complete and the Switch is ready
for you to set up your chosen management method. See
Managing a Switch"
Using Command Line Interface via Telnet
Accessing the Command Line Interface via Telnet or Windows
HyperTerminal using TCP/IP may not work correctly on some platforms
unless it has been configured to send line feeds with carriage returns.
To set this for telnet enter set crlf when in command mode. To set
this for HyperTerminal click on the Settings tab in the Properties screen,
click on ASCII Setup.. and ensure that Send line ends with line feeds is
checked within the ASCII Sending section. You should not configure
HyperTerminal in this way if you are using a console cable to make a
direct connection to the Switch.
1 To start a Telnet session to the unit, click Start in Microsoft Windows
2000/XP.
a Click Run.
b In the dialogue box that appears type the default IP address of the
unit, that is: Telnet 169.254.100.100
c Click OK.
2 Press Enter to open a login prompt.
If the login prompt does not begin immediately, press Return a few times
until it starts.
3 At the login and password prompts, enter
press Return at the password prompt. If you have logged on correctly, the
Manually Configuring IP Information
on page 45.
as your user name and
admin
"Methods of
as your user name and
admin
37