Flat Surround With Trim Kit - Quadra-Fire EXPEDITION II Installation Manual

G. Flat Surround with Trim Kit
Overall
Dimensions
Standard
43" x 31"
Size
Large Size 51" x 34"
Table 21.1
1. Follow steps one through three of Section E. Flat
Surround Installation on page 20.
2. Lift surround assembly to front of appliance
(Figure 20.3 on page 20).
3. Assemble trim as shown in Figure 21.1.
Corner Brackets
Figure 21.1
4. Slide trim over flat surround as shown in Figure 21.2.
NOTE: May need to pull appliance away from fireplace
to clear mantle as you slide the trim over the
flat surround.
Flat
Surround
Figure 21.2
July 30, 2019
Part
Trim Kit
Number
SP-4331 TRIMKIT-4331-NL
SP-5134 TRIMKIT-5134-NL
Trim Kit
Option
5. Install two steel springs at the top on each side and
between the flat surround and the assembled trim kit as
shown in Figure 21.3.
Figure 21.3
6. Install two steel springs on each side of the flat
surround towards the bottom and the assembled trim
kit (Figure 21.4).
Figure 21.4
7. If needed push appliance back into fireplace.
8. Reinstall face to front of
appliance (Figure 20.2 on page 20).
9. Reinstall the door to the face of the
appliance (Figure 20.2 on page 20).
7095-802B
EXPEDITION II INSERT
21