Table of Contents
Advertisement
CAUTION
• When embroidering on large garments
(especially jackets or other heavy fabrics), do
not let the fabric hang over the table.
Otherwise, the embroidery unit cannot move
freely and the embroidery frame may strike the
needle, causing the needle to bend or break
and possibly cause injury.
Place the fabric so that it does not hang off the
table or hold the fabric to keep it from
dragging.
■ Embroidery Needle Plate Cover
Under some conditions, based on the type of fabric,
stabilizer, or thread being used, there may be some
looping in the upper thread. In this case, attach the
included embroidery needle plate cover to the needle
plate. Attach the cover by inserting the two projections on
the underside of the cover into the notches on the needle
plate as shown below.
a
c
To remove the embroidery needle plate cover, place your
fingernail in the groove and lift the plate out.
CAUTION
• Push the embroidery needle plate cover as far
as possible to attach it. If the embroidery
needle plate cover is not securely attached, it
may cause the needle to break.
1 Groove
2 Projection
3 Notch
EMBROIDERING A PATTERN
Embroidering Patterns
a
Prepare embroidery threads of the colors shown on the
screen.
2
1 Embroidery color order
2 Cursor
Memo
• The [+] cursor moves over the pattern, showing
which part of the pattern is being embroidered.
b
Using the automatic needle threader, thread the
machine for the first color. (page 42)
c
Lower the presser foot, then press the "Start/Stop"
button to start embroidering.
When the first color is completely embroidered, the
machine will automatically trim the threads and stop.
The presser foot will then automatically be raised.
On the embroidery color order display, the next
color will move to the top.
1
4
135
Advertisement
Table of Contents
