Table of Contents
Advertisement
■ Adjusting the Guideline Marker Position
If the guideline marker indicates the position incorrectly in
the center needle position, adjust the initial position in the
settings screen.
a
Press
.
The settings screen appears.
b
Press
.
The sewing settings screen appears.
c
Display [Guideline Marker Adjustment] in the sewing
settings screen.
d
Press
.
e
Use
or
to adjust the guideline marker position.
*
: Move the guideline marker to the left.
: Move the guideline marker to the right.
f
Press
twice to return to the original screen.
■ Adjusting the Brightness of the Guideline
Marker
a
a
Follow steps from
to
Marker Adjustment] screen.
b
Use
or
to adjust the brightness of the guideline
marker.
Set the brightness of the guideline marker from [1] for
a dim marker, to [5] for the brightest marker, on the
fabric.
c
Press
twice to return to the original screen.
d
to display the [Guideline
Pivoting
If the pivot function is selected, the machine stops with
the needle lowered (in the fabric) and the presser foot is
automatically raised to an appropriate height when the
"Start/Stop" button is pressed. When the "Start/Stop"
button is pressed again, the presser foot is automatically
lowered and sewing continues. This function is useful
for stopping the machine to rotate the fabric.
CAUTION
• When the pivot setting is selected, the
machine starts when the "Start/Stop" button is
pressed or the foot controller is pressed down
even if the presser foot has been raised. Be
sure to keep your hands and other items away
from the needle, otherwise injuries may occur.
Memo
• When the pivot setting is selected, the height of the
presser foot when sewing is stopped can be
changed according to the type of fabric being
sewn. Press
to display [Pivoting Height] of
the settings screen. Press
height. To raise the presser foot further, increase
the setting.
Note
• The [Needle Position – Up/Down] of the settings
screen, must be set in the down position
the pivot function to be used. When [Needle
Position – Up/Down] is set in the raised position
,
appears as light gray and cannot be used.
• The pivot function can only be used with stitches
where presser foot "J", "N" or "X" (Couching foot)
is indicated in the upper-left corner of the screen. If
any other stitch is selected,
gray and is not available.
• If the pivot function is selected,
beside [Presser Foot Height] in the settings screen
are not available and the setting cannot be
changed.
a
Select a stitch.
USEFUL FUNCTIONS
or
to select the
for
appears as light
and
65
2
Advertisement
Table of Contents
