Toro Groundsmaster 360 Series Operator's Manual page 10

1. 38 mm (1-1/2 inches)
2. 51 mm (2 inches)
5. Install the flange nut bushing, spacer, and bolt.
Torque to 54 to 61 N∙m (40 to 45 ft-lb)
Adjusting the Rollers
Mount the rollers in the lower position when operating
in height of cuts higher than 64 mm (2-1/2 inches) and
in the higher position when operating in height of cuts
lower than 64 mm (2-1/2 inches).
1. Disengage the PTO, release the traction pedal,
and engage the parking brake.
2. Move the throttle lever to the S
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Raise the front of the machine and support it on
jack stands.
4. Remove the fasteners securing each roller on
your cutting unit and move the rollers up or down
as desired; refer to
as applicable for your cutting unit.
Note:
You may need to remove the front roller
for certain Groundsmaster 7200 and 7210
models.
Figure 9
3. 63 mm (2-1/2 inches)
4. 76 mm (3 inches) and
higher
(Figure
position,
LOW
Figure 10 through Figure 14
g004658
1. Front roller
8).
1. Bolt
2. Rear under-cutting unit
roller
3. Spacer
1. Bolt
2. Front under-cutting unit
roller
10
Figure 10
All Cutting Units
2. Roller shaft
Figure 11
Guardian mowers only
4. Nut
5. Bracket
Figure 12
Guardian mower only
3. Nut
4. Bracket
g004487
g004926
g004923