Rigging The Unit For Lifting - Lennox Elite ELS Series Installation Instructions Manual

Rigging the Unit for Lifting

Rig the unit for lifting by attaching four cables to the holes
in the base rail of the unit. See figures 1 through 3.
1 - Remove protective packaging before rigging the
unit for lifting.
2 - Connect the rigging to the holes in each corner of
the unit's base.
3 - All panels must be in place for rigging.
4 - Place a field-provided H-style frame just above the
top edge of the unit. The frame must be of adequate
strength and length. (An H-style frame will prevent
the top of the unit from being damaged.)
Lifting point should be directly above the center of gravity.
Caution - do not walk on unit
Important - all panels must be in place for rigging.
FIGURE 1. ELS072S4S and ELS090S4S
.
Page 12
Lifting point should be directly above the center of gravity.
Caution - do not walk on unit
Important - all panels must be in place for rigging.
FIGURE 2. ELS120S4S, ELS120S4D
and ELS150S4D
Lifting point should be directly above the center of gravity.
Caution - do not walk on unit
Important - all panels must be in place for rigging.
FIGURE 3. ELS180S4D and ELS240S4D
.
.