Table of Contents
Advertisement
LCD DISPLAY FUNCTIONS
13. TRACK – Shows the current track that the unit is playing.
14. MINUTES – Shows the minutes elapsed or remaining depending on
mode setting.
15. SECONDS – Shows the seconds elapsed or remaining depending on
mode setting.
MIXER FUNCTIONS
22
23
24
25
26
16. FRAMES – The CD Player breaks down a second into 75 frames for
accurate cueing. This shows the frames elapsed or remaining
depending on mode setting.
17. TOTAL REMAIN – Displays the total remaining time for the entire
disc.
18. REMAIN – Displays the remaining time for the current track.
19. PITCH – Shows the percentage change in pitch.
20. TIME BAR – This bar gives a visual approximation of a track's or
disc's remaining time. This bar will begin to flash when a CD or a track
is ending.
21. SINGLE – Shows when the unit is set to play just one track at a time.
When this is not lit, the CD will play continuously through all tracks.
This function is controlled by the SING/CONT button.
22. INPUT TOGGLE SWITCH – Switches the input source between the
internal CD decks and the line inputs.
23. CHANNEL GAIN –Adjusts the pre-fader volume for cleaner sound.
27
24. CHANNEL EQ – Adjusts the high, mid and low frequency levels of
each channel.
25. INPUT FADER – Controls individual source levels (channels) in the
mix.
26. REPLACEABLE CROSSFADER – Achieves clean transitions
between the two input channels. "Hard left" selects Channel 1. "Hard
28
right" selects Channel 2. With the crossfader centered, both channels
are live. Use the crossfader for fast and seamless fades from one
29
channel to the other.
Note: The crossfader is user replaceable in case of failure. Simply
unscrew the two large screws that hold it in place, lift it out and dis-
connect its cable. Re-attach the new crossfader and screw the
30
mounting plate back onto the unit - you're back in business!
27. RELAY –Set both sides of the CD player to single mode on the con-
trol. When Disc 1 ends the CD player will automatically change to
Disc 2 and when Disc 2 ends it will return to Disc 1.
31
28. MIC INPUT GAIN – Adjusts the microphone input level.
29. MASTER LEVEL – Controls the overall output level.
30. HEADPHONE LEVEL – Adjusts the cue volume.
32
31. CHANNEL CUE SELECTOR – Used to route channel audio to your
headphones.
32. LEVEL INDICATORS – The dual LEDs indicators are used to indicate
the pre-fader level of channels 1 and 2.
7
Advertisement
Table of Contents
