Table of Contents
Advertisement
CONTROLS OVERVIEW
4
1
2
3
1.
PHONES- Use this stereo jack to connect a pair of headphones.
2.
AUDIO OUT- This stereo line output connects to the line input on
any DJ mixer.
LCD DISPLAY
1
2
1.
TRACK INDICATOR - This 3-digit indicator details a current track.
The number displayed in the track indicator is a direct reference to a
track being selected a track in play, pause, or cue mode.
2.
TIME BAR INDICATOR - This bar visually details the time defined
in the TIME METER (M, S, &F) As with the TIME METER this bar is
also dependent on the selected time function TOTAL REMAIN,
REMAIN or ELAPSED. This bar will begin to flash when 15 seconds
of a track remain and will begin to rap idly flash when three seconds of a
track remain. The flashing bar is a great visual reminder a track is
about to end. The flashing bar will function regardless of which time
mode the unit is in.
3.
TIME DISPLAY - These indicators detail the Minutes, Seconds, and
Frames. The meter will display either the elapsed time, or remaining
time of a track. The time displayed in the meter will directly reflect
the time indicator.
6
5
7
5
7
3
4
6
3.
DIGITALOUTPUT- This coaxial (S/PDIF) digital out-put connects to
any RCA, S/PDIF input, as found on most standard computer sound
cards or CD burners.
4.
FADER START- Connects to any DJ mixer equipped with a fader
start input. This enables the user to start the CD from the cue point,
using the mixer's cross or line fader, depending on the mixer.
5.
VOLTAGE SELECTOR- Used to select the unit's voltage according
to the local setting.
Note: The voltage should preset correctly from the factory, however,
make sure to check it before powering the unit.
✽ Just for Dual Voltage model only.
6.
AC IN- This is the connection for the supplied power cable.
7.
POWER- This button is used to power the unit ON and OFF
4.
TOTAL REMAIN INDICATOR - This indicator is in direct reference to
the TIME METER. When the TOTAL REMAIN indicator is displayed in
the LCD, the time defined will refer to a disc's total remaining time.
The time mode is changed by tapping on TIME button.
5.
REMAIN INDICATOR - This indicator is in direct reference to the TIME
METER. When the REMAIN indicator is displayed in the LCD, the
time defined will refer to a single track's remaining time. The time mode is
changed by tapping on TIME button.
6.
SINGLE INDICATOR - This indicates the unit is in single play mode,
the unit will play a single and return to CUE mode. If the single
indicator is not displayed the unit is in continuous mode. In
continuous mode the drive will play through all the tracks on the
disc.
7.
PITCH METER - This meter displays the pitch percentage being
applied to playback by the PITCH SLIDER If the meter read zero
regardless of the PITCH SLIDER'S position, the PITCH function is
not activated.
5
REAR PANEL
Advertisement
Table of Contents
