Remote Controller (Front Panel) - Stanton C.503 User Manual

5. OUTPUT jacks (RCA, unbalanced)
RCA connectors providing line level output signals, one set each for discs 1 and 2.
Maximum output level is +6dBV (2Vrms)
6. DIGITAL OUTPUT jacks (COAXIAL, S/PDIF)
Coaxial connectors provide S/DIF digital output signals. These connectors can output the 44.1KHz digital signals con-
stantly even if pitch control is activated.
7. FADER START jacks
The C.503 can be controlled using the external fader start command through these jacks. Connect the mixer which sup-
ports the fader start function with appropriate 1/8" Fader Start cable as well as audio signal. (TIP: Start, GND: back cue)
NOTE: When using the fader start function, connect the audio signal with the mixer as well. Also, two 1/8" fader start
cables are supplied in this unit.
8. AUX connectors (not included)
This is for future expansion.
9. REMOTE connector
Use this included connector to connect the remote controller to the main unit.
WARNNING
* DO NOT use any cable except the cable supplied with the C.503.
* Connect the cable in the way shown on the illustration on the rear panel of the C.503. If you connect the cable in any
other way, you may damage the C.503.

1-3. Remote Controller (Front Panel)