Using Sanitize - Fisher & Paykel DD60DAW9 Operating Instructions Manual

Using Sanitize

The sanitize wash modifier adjusts the wash program to meet the conditions required by Section 6, NSF 184 for
sanitization to occur.
While sanitize is running, the wash program is monitored to ensure that these conditions are met.
• Only programs utilizing the sanitize wash modifier are certified to meet the conditions required by
• For sanitization to occur, the temperature of the water needs to reach 70
• If the wash is interrupted or the water supply is turned off during the program, then the heating
At the end of a wash program with sanitize, always check to make sure that sanitization has been successful.
DD*C Models:
If sanitization has been successful:
• The dishwasher will beep
• will show in the display
• The sanitize indicator will remain lit.
• After 30 seconds the display will turn off.
If sanitization has not been successful:
• An alert will sound
https://producthelp.fisherpaykel.com/nz/Clean/DishDrawer%E2%84%A2/Double/DD60DAW9/User_Guide_DD60DAW9/03_O...
Section 6, NSF 184. Other wash programs may not reach the temperatures required for
sanitization to occur. See table on previous page for wash programs that have sanitize available
items are 'dishwasher safe' before running the sanitize modifier.
conditions for sanitization may not be met. You may need to run the program again to ensure
sanitization of your dishes.
0 0
C/158 F. Check that all
Updated: Mon, 11 Nov 2019 03:23:07 GMT
Powered by
4