Table of Contents
Advertisement
Using
SANITIZE
The
wash modifier adjusts the wash program to meet the conditions required by
SANITIZE
Section 6, NSF 184 for sanitization to occur. While
monitored to ensure that these conditions are met.
Only programs utilising the
required by Section 6, NSF 184. Other wash programs may not reach the temperatures
required for sanitization to occur. Refer to 'Wash modifiers' for wash programs that have
sanitize available.
For sanitization to occur, the temperature of the water needs to reach 158°F (70°C). Ensure
all items are dishwasher safe before running the sanitize modifier.
Heavy Medium Light
If the wash is interrupted or the water supply is turned off during the program, the heating
Sanitize
conditions for sanitization may not be met. You may need to run the program again.
1/2
Dry +
Load
1/2
Heavy Medium Light
Sanitize
1/2
Dry +
Load
1/2
wash modifier are certified to meet the conditions
SANITIZE
Auto
Eco
60 min
Rinse
Auto
Eco
60 min
Rinse
SANITIZE
SANITIZE
If sanitization has been successful
The wash will finish as normal.
If sanitization has not been successful
An alert will sound and a code will show on
the display.
1 Check if the water supply has been turned
off or the wash program interrupted.
2 Press and hold
then again to clear the alert code.
3 Reset
SANITIZE
For more information, refer to 'Fault codes'.
is running, the wash program is
to stop the beeping,
and run the cycle again
19
Advertisement
Table of Contents
