Table of Contents
Advertisement
HARDWARE IDENTIFICATION CHART
This chart is provided to help identify the hardware used in the assembly process. Place the washers, the
end of the bolts, or screws on the circles to check for the correct diameter. Use the small scale to check the
length of the bolts and screws.
3/16"
1/4"
0
1/2
1
0
10
20
6
NOTICE: The length of all bolts and screws except those with flat heads is
measured from below the head to the end of the bolt or screw.
Flat head bolts and screws are measured from the top of the
head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.
5/16"
3/8"
1/2
2
1/2
30
40
50
60
8
10
Part No. and Description
64
65
66
67
73
76
77
78
80
86
87
88
89
90
91
48
53
57
1/2"
3
1/2
4
70
80
90
100 110 120 130 140 150
MILLIMETERS
12
Carriage Bolt (M8 x 1.25 x 65mm)
Bolt, Button Head (M8 x 1.25 x 15mm)
Bolt, Button Head (M8 x 1.25 x 20mm)
Bolt, Button Head (M8 x 1.25 x 48mm)
Bolt, Hex Head (M6 x 1 x 38mm)
Screw, Round Head (M5 x 15mm)
Screw, Round Head (M5 x 0.8 x 15mm)
Screw, Flat Head (M5 x 0.8 x 12mm)
Nylock Nut (M8 x 1.25)
Acorn Nut (M6 x 1)
Acorn Nut (M8 x 1.25)
Arc Washer (M6)
Arc Washer (M8)
Lock Washer (M6)
Lock Washer (M8)
Large Washer (M8 x 32mm x 2mm thick)
Plastic Washer (M8 x ø18 x 2mm thick)
Large Washer (M16 x 0.5mm thick)
5
INCHES
1/2
5
1/2
length
length
6
in.
mm.
Qty
4
4
2
2
4
6
4
1
2
4
4
4
8
4
10
2
4
2
Advertisement
Table of Contents
