Stamina Aero Pilates Performer 270 Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
STEP 4
Remove the paper covering from the foam tape inside the FRONT COVER(3) and REAR COVER(4). Place
the FRONT COVER(3) over the FRONT FRAME(1). Place the REAR COVER(4) over the REAR FRAME(2).
Press the covers securely in place.
NOTE:
The securing SCREWS(M6x1x35mm)(36) for the PULLEY SET(22) on each side may need to be
loosened to allow the REAR COVER(4) to fit securely over the frame. Refer to the inset illustration.
When retightening the screws for the PULLEY SETS(22) do not over tighten. The PULLEY SETS(22)
should move freely.
STEP 5
Insert the FOAM PAD ASSEMBLIES(17) into the holes located on the CARRIAGE(7).
8