Stamina INTONE 15-0200 Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
STEP 7
The RIGHT PEDAL(40) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(40) has
NOTE:
right hand threads and is tightened by turning clockwise. The LEFT PEDAL(39) has L stamped on
the end of the pedal shaft. The LEFT PEDAL(39) has left hand threads and is tightened by turning
counter clockwise.
Thread the RIGHT PEDAL(40) onto the right side of the CRANK(8). Thread the LEFT PEDAL(39) onto the
left side of the CRANK(8).
STEP 8
Refer to the illustration. Swing up the METER BRACKET(31) to a proper position. NOTE: If necessary,
loosen the HEX BOLT(M8x1.25x55mm)(66) which secure the METER BRACKET(31) for adjusting.
Install two AA batteries into the METER(32), two batteries included. See page 10 for detailed battery
installation instructions. Run the connection wire on the METER(32) through the hole in the METER
BRACKET(31). Then attach the METER(32) to the METER BRACKET(31) with ROUND HEAD
SCREWS(M5x0.8x10mm)(60). Plug the SENSOR WIRE(33) to the connection wire of the METER(32).
8