Operational Instructions; Seat Adjustment - Stamina 4825 Owner's Manual

OPERATIONAL INSTRUCTIONS

SEAT ADJUSTMENT

Proper seat adjustment is important. There are seven adjustment holes in the REAR FRAME(3). These
adjustment holes allow users to adjust the position of the seat for efficient exercise.
1. Rotate the ADJUSTMENT KNOB(45) counterclockwise until the knob portion can be pulled. Pull the
ADJUSTMENT KNOB(45) and slide the REAR FRAME(3) backward. Lock the REAR FRAME(3) in
position by inserting the pin of the ADJUSTMENT KNOB(45) into one of the adjustment holes in the
REAR FRAME(3), then rotate the ADJUSTMENT KNOB(45) clockwise to lock the REAR FRAME(3)
securely.
2. Sit on the seat and place your feet on the pedals. You should be able to move through a complete pedal
stroke without locking your knees or shifting your hips on the seat. The seat is too close to the pedals if
you have more than a slight bend in your knees at the bottom of the pedal stroke. The seat is too far from
the pedals if you have to completely straighten your knees at the bottom of the pedal stroke.
CAUTION:
1. Do not attempt to adjust the seat while you are on the Magnetic Recumbent 4825 Bike.
2.
Always tighten the ADJUSTMENT KNOB(45) after adjusting the seat to a new position.
LOAD ADJUSTMENT
To increase the load, turn the TENSION KNOB(25) clockwise. To decrease the load, turn the TENSION
KNOB(25) counterclockwise. There are eight levels for the load adjustment.
11