Komatsu 930E-2 Shop Manual page 64

Air pressure must be released from tires with bad
cuts or wear that extends into the plies, before
removal from the vehicle. Also, do not allow per-
sonnel to stand in removal path of tires.
12. Check all tires carefully for serviceability and inflate
to proper pressure.
13. If disconnected, reconnect the parking brake link-
age.
14. Completely service the vehicle as recommended
in Section "P", Lubrication and Service, for both 10
and 100 hour inspections.
15. Adjust all drive belts to specified tension.
16. Make certain that all hydraulic controls, steering
linkage and throttle linkage points are free before
engine start up.
A7-4
17. Use the Operation and Maintenance Manual for
guidance on engine start and vehicle checkout.
Make a thorough check of all hose and line con-
nections for leakage when the engine is running.
18. Before moving the vehicle, cycle all hydraulic con-
trols and steering to verify proper operation. Verify
proper operation of service brakes, emergency
braking system and parking brake. Check ALL
system instruments to insure that all systems are
operational.
19. When all systems are operational and all discrep-
ancies are corrected, road test the vehicle in a
smooth, level, unobstructed area (with qualified,
experienced operator only) to check steering re-
sponse, service brake efficiency, and hydraulic
functions. Only when it is assured that the vehicle
is in safe operational condition should it be turned
over to an operator for production.
20. Fire protection equipment on a machine which has
been in storage should be recharged before the
machine is returned to service.
Storage Procedures A07003