Table of Contents
Advertisement
Warning plates are attached to both the hydraulic tank
and fuel tank to alert technicians not to work on the
truck with the body in the raised position unless
body-up retention device (pins or cable) is in position.
These DANGER plates are mounted on the outside of
each frame rail to alert technicians to read the warning
labels attached to the side of each of the accumulators
(see below) prior to releasing internal nitrogen pres-
sure or disconnecting any hydraulic lines or hardware.
There are similar decals mounted on top of each of the
accumulators (both steering and brake) with the same
DANGER message.
A04039
These WARNING decals are mounted on the side of
each of the accumulators (both steering and brake) to
alert technicians to discharge all gas and hydraulic
pressure, and to read the maintenance/service manual
prior to performing any service.
This Danger plate is attached to all four suspensions.
The plate contains instructions for releasing internal
pressure before disconnecting any hardware.
Serious injury can occur if these directions are not
followed.
A plate on the side of the hydraulic tank furnishes
instructions for filling the hydraulic tank.
Keep the system open to the atmosphere only as long
as absolutely necessary to lessen chances of system
contamination. Service the tank with clean Type C-4
hydraulic oil. All oil being put into the hydraulic tank
should be filtered through 3 micron filters.
Warnings and Cautions
A4-3
Advertisement
Table of Contents
Troubleshooting
