Hardware Identification Chart - Stamina CPS 9200 Indoor Cycle 15-9200 Owner's Manual

HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process. Place the washers or the
ends of the bolts or screws on the circles to check for the correct diameter. Use the small scale to check the
length of the bolts and screws.
3/16" 1/4"
0 1/2 1
0 10 20
6
NOTICE: The length of all bolts and screws, except those with flat heads,
is measured from below the head to the end of the bolt or screw.
Flat head bolts and screws are measured from the top of the
head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.
5/16" 3/8"
1/2 2 1/2
30 40 50 60
8 10
Part No. and Description
55
69
1/2"
3 1/2 4
70 80 90 100 110 120 130 140 150
MILLIMETERS
12
Bolt, Button Head (M8 x 1.25 x 15mm)
Washer (M8)
6
INCHES
1/2 5 1/2
length
length
6
in.
mm.
Qty
4
4