General Maintenance - Spirit Z100 Owner's Manual

STEP 6: Press Start to begin program.
* Chest strap not included.

General Maintenance

Belt and Bed - Your treadmill uses a very high-efficient low-friction bed. Performance is
maximized when the bed is kept as clean as possible. Use a soft, damp cloth or paper
towel to wipe the edge of the belt and the area between the belt edge and frame. Also
reach as far as practical directly under the belt edge. This should be done once a month
to extend belt and bed life. Use water only - no cleaners or abrasives. A mild soap and
water solution along with a nylon scrub brush will clean the top of the textured belt.
Allow to dry before using.
Belt Dust - This occurs during normal break-in or until the belt stabilizes. Wiping excess
off with a damp cloth will minimize buildup.
General Cleaning - Dirt, dust, and pet hair can block air inlets and accumulate on the
running belt. On a monthly basis, vacuum underneath your treadmill to prevent buildup.
Once a year, you should remove the black motor hood and vacuum out dirt that may
accumulate. UNPLUG POWER CORD BEFORE THIS TASK.
BELT ADJUSTMENTS:
If during use you notice that walking belt either shifts to the right or the left of center, first
remove "Safety Key" and unplug equipment from AC power source. Using the M6 Allen
wrench provided, turn right rear roller adjustment as indicated above clockwise no more the
1/4" of a turn. Remove the M6 Allen wrench, insert "Safety Key" and insert AC power cord
into AC outlet. Turn on your treadmill and observe after running a few minutes to see if
18
Z8