Table of Contents
Advertisement
Important
The order to fasten the screws
is, top right, top left, bottom
right and bottom left as viewed
from the right side of the print-
er. If the screws were not fas-
tened in that order, the duplex
unit might not close completely
or the bypass tray might not
work correctly.
H
If the duplex unit is not installed,
skip this step, and go to step I. If
the duplex unit is installed, the
plastic edges on each side of the
unit must be removed. The edges
are held in place by four small
posts. Twist the edges to break
the posts and remove them from
the unit.
I
Slide the bypass tray into the
printer aligning the grooves of
the right and left sides of the by-
pass tray onto the rails inside the
holder.
J
Use the wrench to attach the by-
pass tray to the holder. Fasten the
screws in the order shown in the
illustration.
K
Remove the adhesive tape hold-
ing the bypass tray and cable, and
attach the connector to the socket
on the left bottom side of the back
of the printer.
ZAEP290E
Note
Keep the wrench in the wrench
house inside of the front cover.
Only one wrench can be kept in
the wrench house.
ZAEP300E
Installing Options
1
ZAEP310E
ZAEP320E
ZAEP541E
21
Advertisement
Table of Contents
