Jeep Compass Operating Information Manual page 77

single beep, indicating that the active and hold
status of the two calls have switched. Only one
call can be placed on hold at a time.
Conference Call
When two calls are in progress (one active and
one on hold), press and hold the
you hear a double beep indicating that the two
calls have been joined into one conference call.
Three-Way Calling
To initiate three-way calling, press the
ton while a call is in progress, and make a
second phone call, as described under "Making
a Second Call While Current Call is in Prog-
ress". After the second call has established,
press and hold the button until you hear a
double beep, indicating that the two calls have
been joined into one conference call.
Call Termination
To end a call in progress, momentarily press the
button. Only the active call(s) will be termi-
nated and if there is a call on hold, it will become
the new active call. If the active call is termi-
nated by the phone far end, a call on hold may
not become active automatically. This is cell
phone-dependent. To bring the call back from
hold, press and hold the
hear a single beep.
Redial
• Press the
button until
• After the "Ready" prompt and the following
beep, say "Redial".
• The Uconnect® Phone will call the last num-
ber that was dialed from your mobile phone.
but-
NOTE:
This may not be the last number dialed from
the Uconnect® Phone.
Call Continuation
Call continuation is the progression of a phone
call on the Uconnect® Phone after the vehicle
ignition has been switched to OFF. Call continu-
ation functionality available on the vehicle can
be any one of three types:
• After the ignition is switched to OFF, a call
can continue on the Uconnect® Phone either
until the call ends, or until the vehicle battery
button until you
button to begin.
condition dictates cessation of the call on the
Uconnect® Phone and transfer of the call to
the mobile phone.
• After the ignition is cycled to OFF, a call can
continue on the Uconnect® Phone for a
certain duration, after which the call is auto-
matically transferred from the Uconnect®
Phone to the mobile phone.
• An active call is automatically transferred to
the mobile phone after the ignition is cycled
to OFF.
Uconnect® Phone Features
Language Selection
To change the language that the Uconnect®
Phone is using:
• Press the
button to begin.
• After the "Ready" prompt and the following
beep, say the name of the language you wish
to switch to (English, Dutch, French, Ger-
man, Italian, or Spanish, if so equipped).
• Continue to follow the system prompts to
complete the language selection.
73