Jeep Compass Operating Information Manual page 130

Fully depress the accelerator pedal, slowly,
three times within 10 seconds.
Turn the ignition switch to the OFF/LOCK posi-
tion.
NOTE:
If the indicator message illuminates when
you start the engine, the oil change indicator
system did not reset. If necessary, repeat
this procedure.
24. Malfunction Indicator Light (MIL)
The Malfunction Indicator Light (MIL)
is part of an Onboard Diagnostic sys-
tem called OBD II that monitors emis-
sions, engine, and automatic trans-
mission control systems. The light will illuminate
when the key is in the ON/RUN position before
engine start. If the bulb does not come on when
turning the key from OFF to ON/RUN, have the
condition checked promptly.
Certain conditions, such as a loose or missing
gas cap, poor fuel quality, etc., may illuminate
the light after engine start. The vehicle should
be serviced if the light stays on through several
of your typical driving cycles. In most situations,
126
the vehicle will drive normally and will not
require towing.
CAUTION!
Prolonged driving with the Malfunction Indi-
cator Light (MIL) on could cause damage to
the engine control system. It also could affect
fuel economy and drivability. If the MIL is
flashing, severe catalytic converter damage
and power loss will soon occur. Immediate
service is required.
WARNING!
A malfunctioning catalytic converter, as ref-
erenced above, can reach higher tempera-
tures than in normal operating conditions.
This can cause a fire if you drive slowly or
park over flammable substances such as dry
plants, wood, cardboard, etc. This could re-
sult in death or serious injury to the driver,
occupants or others.
25. Front Fog Light Indicator — If Equipped
This indicator will illuminate when the
front fog lights are on.
26. Electronic Stability Control (ESC) OFF
Indicator Light — If Equipped
This light indicates the Electronic
Stability Control system (ESC) has
been turned off by the driver.
27. Electronic Stability Control (ESC) Mal-
function Indicator Light — If Equipped
The "ESC Malfunction Indicator
Light" in the instrument cluster will
come on when the ignition switch is
turned to the ON/RUN position. It
should go out with the engine run-
ning. If the "ESC Malfunction Indicator Light"
comes on continuously with the engine running,
a malfunction has been detected in the ESC
system. If this light remains on after several
ignition cycles, and the vehicle has been driven
several miles (kilometers) at speeds greater