Manual Transmission - If Equipped; Rear Drive Assembly (Rda) - Awd/4Wd Models Only; Power Transfer Unit (Ptu) - Awd/4Wd Models Only - Jeep Compass Operating Information Manual

CAUTION!
If a transmission fluid leak occurs, visit your
authorized dealer immediately. Severe trans-
mission damage may occur. Your authorized
dealer has the proper tools to adjust the fluid
level accurately.
Fluid And Filter Changes
Refer to the "Maintenance Schedule" for the
proper maintenance intervals. In addition,
change the fluid and filter if the transmission is
disassembled for any reason.
Manual Transmission – If Equipped
Lubricant Selection
Use only the manufacturers recommended
transmission fluid. Refer to "Fluids, Lubricants,
and Genuine Parts" in "Maintaining Your Ve-
hicle" for further information.
Fluid Level Check
Check the fluid level by removing the fill plug.
The fluid level should be between the bottom of
the fill hole and a point not more than 3/16 in
(4.7 mm) below the bottom of the hole.
238
Add fluid, if necessary, to maintain the proper
level.
Frequency Of Fluid Change
Under normal operating conditions, the fluid
installed at the factory will give satisfactory
lubrication for the life of the vehicle. Fluid
changes are not necessary unless lubricant has
become contaminated with water.
NOTE:
If contaminated with water, the fluid should
be changed immediately.
Rear Drive Assembly (RDA) –
AWD/4WD Models Only
Lubricant Selection
Use only the manufacturer's recommended
fluid. Refer to "Fluids, Lubricants, and Genuine
Parts" in "Maintaining Your Vehicle" for further
information.
Fluid Level Check
Visually inspect the unit at each oil change for
leakage. If leakage is detected, check the fluid
level by removing the fill plug. The fluid level
should be maintained between the bottom of
the fill hole to 1/8 in (4 mm) below the fill hole.
Add fluid, if necessary, to maintain the proper
level.
Frequency Of Fluid Change
Refer to the "Maintenance Schedule" for the
proper maintenance intervals.
Power Transfer Unit (PTU) –
AWD/4WD Models Only
Lubricant Selection
Use only the manufacturer's recommended
fluid. Refer to "Fluids, Lubricants, and Genuine
Parts" in "Maintaining Your Vehicle" for further
information.
Fluid Level Check
Visually inspect the unit at each oil change for
leakage. If leakage is detected, Check the fluid
level by removing the fill plug. The fluid level
should be maintained between the bottom of
the fill hole to 1/8 in (4 mm) below the fill hole.
Add fluid, if necessary, to maintain the proper
level.
Frequency Of Fluid Change
Refer to the "Maintenance Schedule" for the
proper maintenance intervals.