Jeep Compass Operating Information Manual page 73

Cancel Command
At any prompt, after the beep, you can say
"Cancel" and you will be returned to the main
menu. However, in a few instances the system
will take you back to the previous menu.
Pair (Link) Uconnect® Phone To A Mobile
Phone
To begin using your Uconnect® Phone, you
must pair your compatible Bluetooth® enabled
mobile phone.
To complete the pairing process, you will need
to reference your mobile phone Owner's
Manual. The Uconnect® website may also pro-
vide detailed instructions for pairing.
The following are general phone to Uconnect®
Phone pairing instructions:
• Press the
button to begin.
• After the "Ready" prompt and the following
beep, say "Device Pairing".
• When prompted, after the beep, say "Pair a
Device" and follow the audible prompts.
• You will be asked to say a four-digit Personal
Identification Number (PIN), which you will
later need to enter into your mobile phone.
You can enter any four-digit PIN. You will not
need to remember this PIN after the initial
pairing process.
• For identification purposes, you will be
prompted to give the Uconnect® Phone a
name for your mobile phone. Each mobile
phone that is paired should be given a unique
phone name.
• You will then be asked to give your mobile
phone a priority level between one and
seven, with one being the highest priority.
You can pair up to seven mobile phones to
your Uconnect® Phone. However, at any
given time, only one mobile phone can be in
use, connected to your Uconnect® System.
The priority allows the Uconnect® Phone to
know which mobile phone to use if multiple
mobile phones are in the vehicle at the same
time. For example, if priority three and priority
five phones are present in the vehicle, the
Uconnect® Phone will use the priority three
mobile phone when you make a call. You can
select to use a lower priority mobile phone at
any time (refer to "Advanced Phone Connec-
tivity" in this section).
Dial By Saying A Number
• Press the
button to begin.
• After the "Ready" prompt and the following
beep, say "Dial".
• The system will prompt you to say the num-
ber you want to call.
• For example, you can say "151-1234 -5555".
• The Uconnect® Phone will confirm the phone
number and then dial. The number will ap-
pear in the display of certain radios.
Call By Saying A Name
• Press the
button to begin.
• After the "Ready" prompt and the following
beep, say "Call".
• The system will prompt you to say the name
of the person you want to call.
• After the "Ready" prompt and the following
beep, say the name of the person you want
to call. For example, you can say "John Doe",
where John Doe is a previously stored name
entry in the Uconnect® phonebook or down-
loaded phonebook. To learn how to store a
69