No Output In Console Window; Invalid Password For Rca Setup; Incorrect Remote Call Of Rca Setup - Fujitsu LAN Console Installation, Configuration And Operation

Error situations
V
Warning
Both of these functions will also reset or terminate an active connection.
An error message is output if there is no connection on the specified port.
7.4.3.2

No output in console window

If output is still not possible in the console window of a connected system
despite the connection being set up successfully, this blockade can be lifted, if
appropriate, from the LAN Console by entering the following command:
echo "\021\c" > /dev/rtty/<line>
<line> is derived from the entry under "DEVICE" from the output of the com-
mand
showlancon -n <ConsoleName>
<ConsoleName> is the symbolic system name of the target system.
7.4.4

Invalid password for RCA setup

It is only possible to access the RCA setup routine, and thus change connection
parameters that have been defined for the RCA, by entering a valid password.
7.4.5

Incorrect remote call of RCA setup

If the remote call of the RCA setup routine – shown below –
rsh <RCA SystemName> setup -display <LAN Console SystemName>:0
is not entered correctly or has been forgotten, the following error message is
output:
Can't open display
Specify the display option or correct your input.
88
Operation
U41224-J-Z916-1-76