Table of Contents
Advertisement
Hardware Setup
Warning:
Step 15. CPU frequency of 83MHz Setting (JP8)
This jumper is used in the CPU frequency selection. It is set to 1-2 for a CPU
frequency of 83 MHz. For all other CPU frequencies it has to be set to 2-3.
CPU frequency
JP8 Setting
Step 16. Select the CPU Burst Mode (JP22)
There are two types of CPU burst modes according to manufacturer
design:
Interleave Burst (CPU: Intel P54C/P55C, AMD
K5/K6/K6-2/K6-III, IDT X86 CPU, Rise mP6)
Linear Burst
CPU Burst
Mode
JP22 Setting
If you are using a Cyrix™ 6x86/L/MX/M II series CPU, set the burst
mode to Linear by shorting pin 1-2 on jumper JP22, and follow the
following steps to select the correct Linear burst mode in BIOS:
During the boot-up initial sequence, press the [Delete] key
1.
to enter the BIOS setup menu.
Select the [CHIPSET FEATURES SETUP] section in BIOS.
2.
In the [CHIPSET FEATURES SETUP] sub-menu, set the
3.
[Linear Burst] field to [Enabled].
Press [Esc] to return to the BIOS main menu.
4.
Then choose [Save & Exit Setup] to re-boot your computer.
5.
Do NOT use an ATX and AT powersupply at the
same time. Use only ONE type of power supply.
83MHz
Close pin1-2
(CPU: Cyrix 6x86/L/MX/MII)
Interleave
®
Intel
P54C/P55C
AMD™ K5/K6/K6-2/K6-III,
IDT X86 CPU, Rise mP6
When using
Intel or AMD
CPUs.
SY-5EHM/5EH5 V1.3
1
Close
2
pin2-3
3
Cyrix™ 6x86/L/MX/MII
When using
1
Cyrix type of
2
CPU.
3
33
All other CPU
Frequencies
1
2
3
Linear
1
2
3
Hide quick links:
Advertisement
Table of Contents
