Hach AquaTrend 51200 Instrument Manual page 79

Print Network Image
51350-18 Appendix B Aquatrend rs232 commandsfm.fm
A sample printout:
[0] PRINT DATA LOG
[0] AVERAGE: CHANNEL A
[0] TIME BASE: 24 HOURS
[0] SENSOR TYPE: 1720D TURB
[0] LOCATION: #1_1720D TURB
[0] UNITS: NTU
[0] 12/11/97 09:44:15 0.133
[0] 12/11/97 09:56:15 0.134
[0] 12/11/97 10:08:15 0.133
[0] 12/11/97 10:20:15 0.133
[0] 12/11/97 10:32:15 0.144
[0] 12/11/97 10:44:15 0.156
[0] 12/11/97 10:56:15 0.158
[0] 12/11/97 11:08:15 0.160
[0] 12/11/97 11:20:15 0.166
[0] 12/11/97 11:32:15 0.168
[0] END OF PRINT
A printed report of the network can be generated by selecting PRINT
NETWORK IMAGE from the Review Net Connections Menu. Note that at
least one SIO must be connected to the network to print the network image.
This report contains the same information that is displayed in LIST
NETWORK DEVICES, ALARM TO RELAY, RECORDER TO ANALOG OUT,
and SENSOR TO DISPLAY.
The report starts with the header line Print Network Image. The next line
contains the date and time of the report. A list of all network devices and the
location of each follows the date and the time. Next, each alarm to relay
connection, recorder to analog out connection, and sensor to display
connection is disPlayed with a blank line separating connections. The report
ends with the footer line END OF PRINT.
For alarm to relay connections, the first line contains the sensor type
(1720D TURB in the sample below) and the sensor location (#1 1720D).
The second line contains the alarm number within the sensor (ALARM 1).
The third line contains the output type (SIGNAL OUT) AND THE OUTPUT
LOCATION (#1_SOM). The fourth line contains the relay number within the
output device (RELAY 1). The same format is used for the recorder to analog
output connections.
For sensor to display connections, the first line contains the sensor type
(1720D TURB) and the sensor location (#1_1720D). The second line contains
the display type (DDM) and the display location (#1_ DDM).
Appendix B
Page 79
Aquatrend RS232 Commands