Dell E28S Series Owner's Manual page 24

Dell PowerEdge R430 system overview
Figure 8 Cabled PSU back panel features (continued)
7. Ethernet connector 2
8. USB connector
9. USB connector
10. System identification button
11. System identification connector
12. Ethernet connector 3
13. Ethernet connector 4
14. Cabled PSU
This table describes about Cabled PSU back panel features. Item 1 is the serial connector, that
enables you to connect a serial device to the system. Item 2 is ethernet connector 1 that supports
10/100/1000 Mbps NIC connectors. Item 3 is the SD vFlash card slot that enables you to insert a
vFlash media card. Item 4 is the iDRAC8 Enterprise port. It is a dedicated management port. The
port is available for use only if the iDRAC8 Enterprise license is installed on your system. Item 5 is
the PCIe expansion card slot, that enables you to connect two low profile PCIe expansion cards.
Item 6 is the video connector, that enables you to connect a VGA display to the system. Item 7 is
ethernet connector 2 that supports 10/100/1000 Mbps NIC connectors. Item 8 is a USB 2.0
compliant port, that enables you to connect USB devices to the system. Item 9is a USB 3.0
compliant port, that enables you to connect USB devices to the system. Item 10 is the system
identification button on the front and back panels, that can be used to locate a particular system
within a rack. When one of these buttons is pressed, the LCD panel on the front and the system
status indicator on the back flashes until one of the buttons is pressed again. Press to toggle the
system ID on and off. If the system stops responding during POST, press and hold the system ID
button for more than five seconds to enter BIOS progress mode. To reset iDRAC (if not disabled in
F2 iDRAC setup) press and hold the button for more than 15 seconds. Item 11 is System
identification connector, that Enables you to connect the optional system status indicator
assembly through the optional cable management arm. Item 12 is ethernet connector 3 that
supports 10/100/1000 Mbps NIC connectors. Item 13 is ethernet connector 4 that supports
10/100/1000 Mbps NIC connectors. Item 14 is the cabled AC PSU rated at 450 W.
Table 7 Cabled PSU back panel features
Item
1
2
3
4
Dell PowerEdge R430 Owner's Manual
24
Indicator, Button, or Icon
Connector
Serial connector
Ethernet port 1
vFlash card slot
(optional)
iDRAC port (optional)
Description
Use the serial port to connect a serial device
to the system. For more information about the
supported serial port, see the Technical
specifications section.
Use the Ethernet port to connect Local Area
Networks (LANs) to the system. For more
information about the supported Ethernet
ports, see the Technical specifications section.
Use the vFlash media card slot to insert a
vFlash media card.
Use the iDRAC8 Enterprise port to remotely
access iDRAC. For more information, see the
Integrated Dell Remote Access Controller User's
Guide at Dell.com/idracmanuals.