Dell E28S Series Owner's Manual page 161

4. If installed, remove the expansion card riser.
Procedure
1. Locate the battery socket. For more information, see the System board connectors section.
CAUTION To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
2. Place your finger between the securing tabs at the negative side of the battery connector
and lift the battery out of the socket.
Figure 76 Removing the system battery
a. system battery
b. system battery slot
3. To install a new system battery, hold the battery with the "+" facing up and slide it under
the securing tabs.
4. Press the battery into the connector until it snaps into place.
Figure 77 Installing the system battery
a. system battery
b. system battery slot
After you finish
1. Install the cooling shroud.
2. If removed, install the expansion card riser.
3. Follow the procedure listed in the After working inside your system section.
4. While booting, press F2 to enter System Setup and ensure the battery is operating properly.
Installing and removing system components
Dell PowerEdge R430 Owner's Manual
161