Jeep Grand Cherokee 2013 Operating Information Manual page 167

4. Electronic Stability Control (ESC) Activation/
Malfunction Indicator Light — If Equipped
The "ESC Activation/Malfunction
Indicator Light" in the instrument
cluster will come on when the igni-
tion switch is turned to the ON/
RUN position. It should go out with
the engine running. If the "ESC Activation/
Malfunction Indicator Light" comes on continu-
ously with the engine running, a malfunction
has been detected in the ESC system. If this
light remains on after several ignition cycles,
and the vehicle has been driven several miles
(kilometers) at speeds greater than 30 mph
(48 km/h), see your authorized dealer as soon
as possible to have the problem diagnosed and
corrected.
NOTE:
The "ESC Off Indicator Light" and the "ESC
Activation/Malfunction Indicator
come on momentarily each time the ignition
switch is turned to ON/RUN.
Each time the ignition is turned to ON/RUN,
the ESC system will be ON, even if it was
turned off previously.
The ESC system will make buzzing or click-
ing sounds when it is active. This is normal;
the sounds will stop when ESC becomes
inactive following the maneuver that caused
the ESC activation.
5. TOW/HAUL Indicator Light — If Equipped
This light will illuminate when the
TOW/HAUL button has been se-
lected. The TOW/HAUL button is lo-
cated in the center of the instrument
panel (below the climate controls).
6. Turn Signal Indicator
The arrows will flash with the exterior
turn signals when the turn signal lever
is operated. A tone will chime, and an
Light" EVIC message will appear if the turn signals are
left on for more than 1 mile (1.6 km).
NOTE:
Check for an inoperative outside light bulb if
either indicator flashes at a rapid rate.
7. High Beam Indicator
Indicates that headlights are on high
beam.
8. Front Fog Light Indicator — If Equipped
This indicator will illuminate when the
front fog lights are on.
9. Hill Descent Control Indicator Light — If
Equipped
The symbol indicates the status of
the Hill Decent Control (HDC) fea-
ture. The lamp will be on solid
when HDC is armed. HDC can only
be armed when the transfer case is
in the "4WD Low" position and the vehicle
speed is less then 30 mph (48 km/h). If these
conditions are not met while attempting to use
the HDC feature, the HDC indicator lamp will
flash on/off.
163