Suzuki Grand Vitara Service Manual page 379

2. Spacer
8) With latch of tensioner adjuster No.1 returned and
plunger (1) pushed back into body, insert stopper (4)
into latch (2) and body (3).
After inserting it, check to make sure that plunger will
not come out.
9) Install timing chain tensioner (2) adjuster No.1 (1).
Tightening torque
Timing chain tensioner adjuster No.1 bolt (a): 11
N·m (1.1 kgf-m, 8.0 lb-ft)
10) Pull out stopper (3) from adjuster No.1.
11) Apply engine oil to sliding surface of timing chain
guide No.1 (1) and then install it.
Tighten guide bolts to specified torque.
Tightening torque
Timing chain guide No.1 bolt (a): 9 N·m (0.9 kgf-
m, 6.5 lb-ft)
www.CarGarage.ir
I2RH01140086-01
12) Check that dark blue and yellow plates of 1st timing
chain are in match with match marks on sprockets
respectively.
I2RH01140087-01
13) Install 2nd timing chain. Refer to "2nd Timing Chain
and Chain Tensioner Removal and Installation: For
J20 Engine" for installation.
14) Install timing chain cover. Refer to "Timing Chain
Cover Removal and Installation: For J20 Engine" for
installation.
15) Install cylinder head cover. Refer to "Cylinder Head
I2RH01140088-01
Cover Removal and Installation: For J20 Engine" for
installation.
16) Install oil pan. Refer to "Oil Pan and Oil Pump
Strainer Removal and Installation: For J20 Engine in
Section 1E" for installation.
17) Install engine assembly to vehicle referring to
"Engine Assembly Removal and Installation: For J20
Engine".
www.CarGarage.ir
Engine Mechanical: For J20 Engine 1D-93
1. Match mark on idler sprocket
2. Dark blue plate
3. Match mark on crank timing sprocket
4. Yellow plate
I2RH01140089-01
I2RH01140090-01