Continuously Variable Transmission (Cvt) Fluid - MARUTI SUZUKI Baleno RS Owner's Manual

Continuously Variable
Transmission (CVT) Fluid
(If equipped)
Specified Fluid
Use SUZUKI CVT FLUID GREEN-2.
Fluid Level Check
NOTICE
Driving with too much or too little
fluid can damage the transmission.
You must check the fluid level with the CVT
fluid at normal operating temperature.
To check the fluid level:
1) To warm up the CVT fluid, drive the
vehicle or idle the engine until the tem-
perature gauge indicates normal oper-
ating temperature.
2) Then drive for ten more minutes.
NOTICE
Be sure to use the specified CVT
fluid. Using CVT fluid other than
SUZUKI CVT FLUID GREEN-2 may
damage the CVT of your vehicle.
NOTE:
Do not check the fluid level if you have just
driven the vehicle for a long time at high
speed, or if you have driven in city traffic in
hot weather. Wait until the fluid cools down
(about 30 minutes), or the fluid level indi-
cation will not be correct.
3) Park your vehicle on level ground.
4) Apply the parking brake and then start
the engine in "P" (Park). Let it idle for
two minutes and keep it running during
the fluid level check.
5) With your foot on the brake pedal,
move the gearshift lever through each
gear, pausing for about three seconds
in each range. Then move it back to the
"P" (Park) position.
WARNING
Be sure to depress the brake pedal
when moving the gearshift lever, or
the vehicle can move suddenly.
EXAMPLE
68PH00714
INSPECTION AND MAINTENANCE
EXAMPLE
68PH00715
EXAMPLE
(1)
(3)
(2)
68PH00716
(1) FULL
(2) LOW
(3) The lowest point = Fluid level
68PH5-74E
7-18