Simrad ES80 Reference Manual page 200

Simrad ES80 Reference Manual
Procedure
1 If you have more than one Processor Unit
connected to your ES80 system:
a Disconnect all computers from the
ES80 system except one.
b Turn each transceiver off and on.
This is important to ensure that each
transceiver has an IP address from the
only Processor Unit currently online.
2 Turn on the Processor Unit, and start the ES80 program.
3 Select
Operation
4 Open the
Setup
5 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
6 On the left side, select
Observe that the
7 Download the new software version.
a In the list of transceivers, select the
transceiver you wish to upgrade.
b Select
Download Transceiver Software
c In the dialog box that opens, choose
the software file you wish to use, and select
The file name reflects the type of receiver the software is created for.
d Observe the information provided in the next dialog box.
e If you still wish to download and install the software, select
Note
The communication between the Processor Unit and the Wide Band
Transceiver (WBT) must not be interrupted while the software is downloaded!
f Wait while the software downloads.
g Observe the resulting message.
If the download process fails, restart it.
198
, and set it to Inactive.
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
.
Transceiver
Transceiver Installation
.
page opens.
.
.
Open
.
Yes
406273/C