Interlogix TruPortal TP-ADD-1DIP Quick Reference page 8

Callout Description
LEDs
1 D85 Power On
2 D14 Offline
3 D15 Address RX
4 D16 Badge Activity
5 D17 Database Pending
6 D18 File System Active
7 D19 Watchdog
8 D20 Flash Upload
9 D21 Shutdown Request
10 D33 Strike Activated
11 D24 FACP (not supported by IPSDC)
12 D25 Door Contact
13 D26 Door REX
14 DS and DS5 Link
15 DS4 and DS8 Collision
16 DS3 and DS7 Full Duplex
17 DS2 and DS6 100/10 Mbps
Switches
18 SW4 Boot Mode
19 SW5 Hardware Reset
20 SW6 Shutdown Request
21 SW7 Restore Defaults
8
Figure 11: IPSDC LEDs and Switches
State
ON: power is present
Normally OFF
Normally OFF
Normally OFF; flashes when badge is read
Flashes while waiting to receive database from host
Normally OFF
Flashes one beat per second if watchdog is healthy
ON when IPSDC is booting up
Normally OFF/Flashes and then ON
ON during strike activation
ON = contact open
ON = contact closed; OFF = contact open; Flashing = fault
ON = contact closed; OFF = contact open; Flashing = fault
ON = link activity; OFF = no activity. Flashing = network activity
ON = Collision
ON = Full duplex; OFF = Half duplex
ON = 100 Mbps; OFF = 10 Mbps
Manually enables the ICT.
Reboots the IPSDC.
Initiates Safe Shutdown of the IPSDC.
Returns configuration to factory defaults.
TruPortal IP-based Single Door Controller Quick Reference