Interlogix TruPortal TP-ADD-1DIP Quick Reference page 6

The following table lists the items shown in
Callout Description
1 IPSDC board with overlay
2 Reader In (Access) J1
3 Door Contact, Request to Exit (RTE) and
Strike Relay J2
4 Strike Voltage Select W2
5 Custom Wiegand Card Format DIP switch
SW1
6 Reader Out (Egress) J3
7 DIP Switch 2 (set all to OFF) SW2
8 Status LEDs typical
9 UCSIMMPlus Module
10 IPSDC board mounting holes
6
Figure 9: IPSDC Board Layout
Figure 9.
Callout Description
11 Network (Ethernet) port J10
12 Console port J9
13 Enclosure tamper W5
14 Boot Mode switch SW4
15 Hardware Reset switch SW5
16 Shutdown Request switch SW6
17 Restore Defaults switch SW7
18 Aux Power Input 24 VDC
Note: Jumpers between pins 3 and 4, and pins 4
and 5 must remain in place.
19 Fire Alarm Control Panel (FACP) Input J6
Note: The IPSDC does not support FACP so
this jumper must remain in place.
TruPortal IP-based Single Door Controller Quick Reference