Table of Contents
Advertisement
9. CONNECT WIRING
Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all applicable
codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting
means to prevent power to be switched on accidentally.
Detach the junction box cover from the top of the hood by removing both retaining
screws. Set aside the cover and the screws.
Remove a knockout from the junction box cover top.
Install a UL approved strain relief (not included) on the house power cable at 4"
from the cable end. Run the power cable in the junction box cover opening, then
use the strain relief to secure the house power cable to the junction box cover.
Connect power cable to range hood wiring using included wire connectors.
Connect BLACK to BLACK, WHITE to WHITE and GREEN or BARE WIRE to
GREEN. DO NOT FORGET TO CONNECT THE GROUND.
Reinstall the junction box cover. Make sure all wires are inside the junction box
cover.
Make sure not to pinch any wire when reinstalling the junction box cover.
WARNING
!
HE0361
CAUTION
6
HO0296
HR0226
S
TRAIN RELIEF
HD1157
Advertisement
Table of Contents
