Table of Contents
Advertisement
5
Press CHAINE +/– (repeatedly) to select the appropriate TV system
CHAINE
for your area.
Select "L" for the L TV system (SECAM), or "G" for the B/G TV
system (PAL).
6
Tune the TV to the same channel
shown in the VCR display window so
that the picture on the right appears
clearly on the TV screen.
Refer to your TV manual for TV
tuning instructions.
If you select the wrong TV system in
step 5, the picture on the right may
not appear. Select the appropriate TV system and tune the TV
again.
If the picture does not appear clearly, see "To obtain a clear picture
from the VCR" below.
7
Press REGL CANAL.
REGLAGE
AUTO
You have now tuned your TV to the VCR. Whenever you want to
play a tape, set the TV to the video channel.
REGL CANAL
To check to see if the TV tuning is correct
Set the TV to the video channel and press CHAINE +/– on the VCR. If the
TV screen changes to a different programme each time you press
CHAINE +/–, the TV tuning is correct.
To obtain a clear picture from the VCR
If the screen does not appear clearly in step 6 above, go to step 7 to finish
this procedure once. Then start again from step 2. After pressing REGL
CANAL in step 2, press CHAINE +/– while the RF channel is displayed, so
that another RF channel appears. Then tune the TV to the new RF channel
so that a clear picture appears.
MAGNETOSCOPE SONY
continued
Tuning your TV to the VCR
21
Advertisement
Table of Contents
