Komatsu 830E-AC Shop Manual page 74

11. Install fully charged batteries in unit. Clean con-
nectors and connect battery cables. Compart-
ment must be free of corrosion. Secure
batteries with hold downs.
12. Check all electrical cables for weathering,
cracks and/or damage. Replace any defective
cables.
Air pressure must be released from any tires with
bad cuts or wear that extends into the plies,
before removing from the vehicle. Also, do not
allow personnel to stand in removal path of tires.
13. Check all tires, carefully for serviceability and
inflate to proper pressure.
14. If disconnected, reconnect the parking brake
linkage.
15. Completely service the vehicle as recom-
mended in Section P, Lubrication and Service,
for both 10 and 100 hour inspections.
16. Adjust all drive belts to the specified tension.
17. Make certain that all hydraulic controls, steering
linkage and throttle linkage points are free and
properly lubricated before engine start up.
A7-6
18. Use the Operation and Maintenance Manual for
guidance on engine start and vehicle checkout.
Make a thorough check of all hose and line con-
nections for leakage when the engine is run-
ning.
19. Before moving the vehicle, cycle all hydraulic
controls and steering to verify proper operation.
Verify proper operation of service brakes, emer-
gency braking system and parking brake.
Check all system instruments to insure that all
systems are operational.
20. When all systems are operational and all dis-
crepancies are corrected, road test the vehicle
in a smooth, level, unobstructed area (with qual-
ified, experienced operator only) to check steer-
ing response, transmission shifting, service
brake efficiency, and hydraulic functions. Only
when it is assured that the vehicle is in safe
operational condition should it be turned over to
an operator.
21. Fire protection equipment on a machine which
has been in storage should be recharged before
the machine is returned to service.
Storage Procedures A07006