Sony SLV-SE440K Operating Instructions Manual page 80

Symptom
The SHOWVIEW menu
or the TIMER
PROGRAMMING menu
does not appear.
The VPS/PDC function
does not operate
properly.
The SYNCHRO REC
button turns off while
recording or does not go
back to recording
standby mode.
The Synchronized
Recording function does
not work.
The programme recorded
with the Synchronized
Recording function is
incomplete.
You cannot watch Canal
Plus programmes when
the VCR is in standby
mode.
A Canal Plus programme
is always recorded
scrambled.
80
Troubleshooting
Remedy
• Check that TIMER METHOD in the EASY OPERATION
menu is set correctly (see page 73).
• Check that the clock and the date are set correctly.
• Check that the VPS/PDC time you set is the correct one
(there might be a mistake in the TV programme guide). If
the broadcast you wanted to record did not send the good
VPS/PDC information, the VCR will not start recording.
• If the reception is poor, the VPS/PDC signal might be
altered and the VCR might not start recording.
• The tape has reached its end. Insert a new tape and press
SYNCHRO REC again.
• The connected equipment was not turned off.
Turn off the connected equipment and press SYNCHRO
REC again.
• There was a power failure. Press SYNCHRO REC again.
• If the settings for timer recordings and Synchronized
Recording overlap, the programme that starts first has
priority and the second programme starts recording only
after the first programme has finished.
• There was a power failure. Press SYNCHRO REC again.
• Check that DEC is set to ON for this channel in the TV
STATION TABLE menu.
• Make sure the Canal Plus Scart cable is plugged securely.
• Make sure the Canal Plus Scart cable is plugged securely.
• Check that DEC is set to ON for this channel in the TV
STATION TABLE menu.