Table of Contents
Advertisement
Step 5 : Tuning your TV to the VCR
If your TV has a Scart (EURO-AV) connector, see page 20.
If your TV does not have a Scart (EURO-AV) connector
Follow the steps below so that your TV will properly receive the video
signals from your VCR.
1
Press RF CHANNEL on the VCR lightly.
AUTO SET UP
The factory-preset RF channel appears in the display window.
The VCR signal is output through this channel to the TV.
RF CHANNEL
2
Turn on your TV and select a programme position for the VCR
picture.
This programme position will now be referred to as the video
channel.
3
Tune the TV to the same channel
shown in the VCR display window
so that the picture on the right
appears clearly on the TV screen.
Refer to your TV manual for TV
tuning instructions.
If the picture does not appear
clearly, see "To obtain a clear
picture from the VCR" below.
RF CHANNEL
PROGRAM +/–
SONY VIDEO CASSETTE RECORDER
continued
Tuning your TV to the VCR
19
Advertisement
Table of Contents
