Step 2 : Setting Up The Remote Commander - Sony SLV-N99 Operating Instructions Manual

Step 2 : Setting up the remote commander

Inserting the batteries
Insert two R6 (size AA) batteries by
matching the + and – on the batteries to
the diagram inside the battery
compartment.
Insert the negative (–) end first, then
push in and down until the positive (+)
end clicks into position.
Using the remote commander
You can use this remote commander to
operate this VCR and a Sony TV.
Buttons on the remote commander
marked with a dot (•) can be used to
operate your Sony TV. If the TV does
not have the
sensor, this remote commander will not
operate the TV.
To operate
the VCR
a Sony TV
10
Setting up the remote commander
symbol near the remote
Set [TV] / [MAGN] to
[MAGN] and point at the remote sensor at the VCR
[TV] and point at the remote sensor at the TV
Remote sensor
1 2 3
4 5 6
7 8 9
0
[TV] /
[MAGN]